Espuma, Cream Whipper and Stabilisation
Programme 8 · 60 min
Learning goals
- Fill and use a cream whipper safely
- Prepare hot and cold espuma bases
- Create texture and foam with xanthan and lecithin
Theory
An espuma is a liquid with gas dissolved in it under pressure in a cream whipper, which turns to foam as it comes out. For the foam to hold, the liquid must contain a structuring agent: fat (cream), gelatine, starch or protein. Xanthan is a hydrocolloid that thickens liquids even when cold; lecithin creates a light, airy foam (air) on the surface of a liquid.
Technique and the science behind it
N2O dissolves well in fat and water; when the pressure is released, it forms bubbles and expands the liquid. How long the foam lasts depends on the thickness and viscosity of the liquid film around the bubbles. At a very low dose (0.1-0.3%), xanthan increases viscosity and is largely unaffected by heat and acid.
Step by step
- Prepare the base: for a cold espuma, whipping cream (35% fat) or a flavoured liquid supported with gelatine (about 1-1.5% of the liquid); for a hot espuma, a purée or sauce bound with butter, cream or starch.
- Pass the base through a fine sieve; even the smallest particle will block the nozzle of the cream whipper.
- Fill the cream whipper to no more than the marked level (usually half to two-thirds) and close the lid tightly.
- Fit 1 charger for a 0.5 litre cream whipper and 2 for a 1 litre cream whipper; after each charger, shake the cream whipper vigorously 4-6 times.
- Leave the cold espuma in the fridge for at least 1-2 hr; hold the hot espuma in a 60-65°C water bath.
- To serve: hold the cream whipper upside down and press the trigger gently to dispense.
- Lecithin foam: add 0.5-1% lecithin to the flavoured liquid, hold a stick blender half-submerged at the surface to incorporate air and spoon off the foam that collects on top.
- Xanthan: sprinkle 0.1-0.3% over the liquid and blend; it thickens in a few min.
Critical temperatures and measurements
- Cream whipper: 1 charger for 0.5 litre, 2 chargers for 1 litre
- Gelatine in cold espuma: ~1-1.5%
- Xanthan: 0.1-0.3%
- Lecithin foam: 0.5-1%
- Holding hot espuma: 60-65°C
Safety
- Use only food-grade N2O chargers; CO2 chargers are not suitable for espuma.
- Never open the lid while the cream whipper is under pressure; release all the gas first.
- With hot espuma, do not heat the cream whipper above the temperature the manufacturer allows.
Common mistakes
- Liquid is running out of the cream whipper, no foam: Too little gas or not enough shaking; add another charger and shake.
- Nozzle is blocked: The base was not strained; empty, strain and refill.
- Foam collapses straight away: The base is too thin; strengthen it with gelatine, cream or xanthan.
Professional tips
- The cream whipper is also used for rapid infusion: add fruit or herbs to the liquid, charge with gas and release the gas after 1-2 min.
- If you mix the xanthan with sugar before sprinkling, it will not clump.
Practice exercise
From the same flavoured cream, make three espumas: plain cream, with gelatine and with xanthan. After 10 min, measure the height of the foam.