Sautéing and Searing
Programme 3 · 50 min
Learning goals
- Bring the pan to the right temperature
- Explain the effect of an overcrowded pan
- Form a brown crust on meat and vegetables
- Make a pan sauce (deglaze)
Theory
Sautéing (French sauter: to jump) is cooking in a little fat over high heat, turning the food often. Searing is forming a brown, aromatic crust on the surface of a protein. Contrary to popular belief, searing does not "seal in" the juices; its purpose is flavour and texture. The sticky brown layer left on the bottom of the pan (the fond) is the most valuable ingredient of a sauce.
Technique and the science behind it
Browning (the Maillard reaction) speeds up above about 140°C. While there is water on the surface, the temperature cannot rise above 100°C; this is why a wet or overcrowded pan does not brown, it stews. The same happens when meat goes into a cold pan. The milk solids in butter start to burn at around 150°C; for high heat, use an oil with a high smoke point first and add the butter at the end.
Step by step
- Take the meat out of the fridge 20–30 min before cooking, dry it thoroughly with paper towels and season both sides with salt.
- Heat the empty pan over medium-high heat for 2–3 min. It is ready when a few drops of water roll around the pan like a single bead.
- Add the oil; it should shimmer and ripple slightly, but not smoke.
- Lay the meat in the pan away from you. The meat should fill no more than two-thirds of the pan surface.
- Do not move the meat. Turn it when it releases from the pan by itself (2–3 min).
- In the last 1–2 min, add the butter, crushed garlic and thyme; tilt the pan slightly and spoon the foaming butter over the meat (arroser).
- Transfer the meat to a plate and let it rest. Sauté the mushrooms in the same pan in a single layer, leaving the salt until the end.
- Deglaze: without taking the pan off the heat, pour in the stock, scrape the brown layer from the bottom with a wooden spoon and reduce by half. Take off the heat and finish with a piece of cold butter.
Critical temperatures and measurements
- Browning: about 140°C and above at the surface
- Milk solids in butter: burn at ~150°C
- Pan fullness: no more than two-thirds
Safety
- Lay the meat in the pan away from you; the oil spatter will not come towards you.
- Never pour water on burning oil; cut off the air with a lid or a dry tray and turn off the heat.
- Do not leave the pan handle pointing towards the edge of the worktop.
Common mistakes
- The meat came out grey and watery: The pan was not hot enough, the meat was wet or the pan was overcrowded. Dry it and cook in batches.
- The meat stuck to the pan: You are trying to turn it too early; once the crust has formed it releases by itself.
- The butter burnt: Leave the butter until the end, or lower the heat as you add it.
- The mushrooms released water: Leave the salt until the very end and do not overcrowd the pan.
Professional tips
- A stainless steel pan leaves a fond and is ideal for pan sauces; a non-stick pan does not.
- Finish thick cuts of meat in the oven after searing.
- Cut vegetables to the same size; sautéing is a fast method and does not forgive different sizes.
Practice exercise
Cook the same mushrooms three ways: (1) starting in a cold pan, (2) in an overcrowded pan, (3) in a hot pan, in a single layer with the salt at the end. Compare colour, texture and water loss, and take photos.