Chocolate Tempering and Ganache
Programme 7 · 75 min
Learning goals
- Explain why tempering is needed
- Temper using the seeding method
- Test the temper
- Make ganache in the right proportions
Theory
Tempering is the process of resolidifying melted chocolate so that the cocoa butter forms the right crystal structure. Properly tempered chocolate is glossy, makes a clean "snap" when broken, does not melt immediately in the hand and releases easily from the mould. Ganache is an emulsion of chocolate and cream; by changing the proportions you get a sauce, a filling or a truffle consistency.
Technique and the science behind it
Cocoa butter can solidify in six different crystal forms; only the "form V" crystal gives gloss and snap. Melting the chocolate completely (45–50°C for dark) destroys all the crystals. Cooling (27–28°C) starts crystallisation, and gentle reheating (31–32°C) melts the unstable crystals and leaves only form V. In ganache, the water in the cream emulsifies the fat of the chocolate.
Step by step
- Chop the chocolate finely. Melt two-thirds of it over a bain-marie (the water must not boil or touch the bowl) up to 45–50°C.
- Seeding: add the third of chopped chocolate you set aside and stir until it melts, bringing the temperature down to 27–28°C. (Alternative: tabling on marble with a spatula.)
- Put the bowl back over the bain-marie for a few seconds to raise it to 31–32°C. Do not go above this temperature.
- Test: dip the tip of a knife in the chocolate and leave it at 18–20°C. If it sets glossy and without streaks within 3–5 min, it is tempered.
- Pour into the moulds, turn them upside down to drain off the excess and leave to set. Keep in the fridge for no more than 10 min; a long time in the fridge causes moisture and bloom.
- Ganache: heat the cream to just below boiling point (80–85°C), pour it over the chopped chocolate and leave for 1 min.
- Starting from the centre, stir with a spatula in small circles; a glossy emulsion spreads from the centre outwards. For a smoother texture, blitz with a stick blender without letting in air.
- When the ganache falls to 35–40°C, add the room-temperature butter.
Critical temperatures and measurements
- Dark: 45–50°C → 27–28°C → 31–32°C
- Milk: 40–45°C → 26–27°C → 29–30°C
- White: 40°C → 25–26°C → 28–29°C
- Seed proportion: about 25–30% of the melted chocolate
- Ganache (dark:cream): 1:1 sauce/filling, 2:1 truffle; milk 2–2.5:1; white 3:1
Safety
- Steam from the bain-marie can burn your hand; hold the bowl with a cloth.
- If a single drop of water gets into the chocolate, it thickens and turns grainy (seizes); keep spoons dry.
Common mistakes
- The chocolate is dull and streaky: The temper did not hold; melt it again to 45–50°C and repeat the process.
- The chocolate seized: Water got in; use this chocolate for ganache or a sauce.
- The ganache split: It was too hot or the proportions were wrong; add 1–2 tbsp of warm milk and re-emulsify with a stick blender.
- It did not release from the mould: The temper did not hold or the mould was dirty; polish the mould with cotton wool.
Professional tips
- Adding food-grade cocoa butter (mycryo) at 1% gives fast, reliable seeding.
- Couverture chocolate contains a high proportion of cocoa butter; it is better suited to tempering than ordinary bar chocolate.
- While working, bring the tempered chocolate back to 31–32°C from time to time.
Practice exercise
Temper some of the same chocolate and leave some untempered, then spread both thinly on acetate. Once set, compare the gloss, the snap and the time it takes to melt in the hand.