Hawaiian Coconut Pudding

Hawaiian Coconut Pudding Haupia

A Local Hawaiian dessert. Takes 1 hr 10 min · +2 hr chilling, Serves 4. Difficulty: medium.

At a glance

Total time
1 hr 10 min · +2 hr chilling
Serves
Serves 4
Difficulty
Medium
Cuisine
Local Hawaiian cuisine
Dish type
Dessert
Diet
Gluten-free
Allergens
Milk, Tree nuts

Open in the app

Ingredients

  • Coconut milk (20×20 cm tin, 16 squares): 200 g unsweetened desiccated coconut
  • 800 ml water

Pudding

  • 700 ml homemade coconut milk
  • 100 g caster sugar
  • 1/4 tsp salt
  • 60 g cornflour (pia, Polynesian arrowroot, in the original recipe)
  • 120 ml cold water

To finish (optional)

  • 2 tbsp desiccated coconut

Equipment

  • Saucepan
  • Blender
  • Mixing bowls
  • Fine sieve / chinois
  • Muslin
  • Cake tin
  • Balloon whisk
  • Silicone spatula
  • Palette knife
  • Cling film
  • Chef's knife
  • Probe thermometer (optional)
  • Frying pan (optional)

Method

  1. Heat the water: Heat the 800 ml water in a saucepan to 80°C. Without a thermometer, take it off the heat when the first small bubbles appear on the bottom. Boiling water can make the coconut fat taste bitter, while lukewarm water does not draw out enough of the cream
  2. Blend and steep: Put the coconut and hot water in a blender and blend on high for 2 min, holding the lid down with a cloth. Tip into a bowl and leave to steep for 10 min. The heat and the broken-down fibres release the fat and cream into the water. In Polynesia this is done by hand with freshly grated coconut
  3. Squeeze out the milk: Set a fine sieve over a bowl, line it with muslin and pour in the mixture. Gather the corners of the muslin, twist and squeeze out all the milk. You should have about 700 ml of thick, cream-coloured milk. If you have less, add 100 ml hot water to the pulp and squeeze again. This milk is fresher and more delicately scented than tinned
  4. Prepare the tin: Wipe the inside of a 20×20 cm cake tin with a very thin film of oil or wet it with cold water, so the haupia cuts cleanly and unmoulds easily
  5. Slake the cornflour: Whisk the cornflour with the 120 ml cold water in a small bowl to a lump-free slurry with the consistency of milk. Cornflour added straight to hot liquid turns lumpy at once
  6. Cook: Put the coconut milk, sugar and salt in a clean saucepan and heat over a medium heat for about 5 min, until the sugar dissolves and small bubbles appear at the edges. Stir the slurry again and pour it into the pan in a thin stream, whisking constantly. Lower the heat to medium-low and cook for 6-8 min, scraping the bottom and corners of the pan with a spatula. The mixture first thickens, then turns glossy and slightly translucent and leaves a thick trail behind the spatula. From this point, cook for another 1 min, stirring, to get rid of the raw starch taste
  7. Pour into the tin: Pour the haupia straight into the tin and level the surface with a palette knife. Press cling film directly onto the surface to stop a skin forming. Let cool at room temperature for 20 min, then chill in the fridge for at least 2 hr, until it cuts with straight sides and is wobbly but holds together
  8. Toast the coconut: While the haupia chills, toast the coconut for the optional finish in a dry frying pan over a low heat for 3-4 min, stirring constantly, until pale golden. Tip it onto a plate straight away, as it burns if left in the pan
  9. Cut and serve: Dip a chef's knife in hot water, wipe it dry and cut the haupia into 16 squares of 5×5 cm, reheating the knife for each cut. Lift the squares with a palette knife and arrange them on a serving plate, spaced apart. Scatter over the toasted coconut if you like. Serve cold

Chef's note

Haupia is the classic dessert of the Hawaiian lūʻau table. It was once made by setting coconut cream thickened with pia starch in ti leaves. Today cornflour is common. Making coconut milk from scratch lets you control the fat content. For a richer haupia, do not add a second pressing even if you are short of milk. Instead, make up for the shortfall by reducing the sugar and cornflour in proportion.

Frequently asked questions

How do you know when Haupia has set well enough to cut?
Chill the haupia in the tin in the fridge for at least 2 hours. When cut, it should have straight edges and a wobbly but firm texture that doesn't fall apart.
Why mix the cornflour with cold water?
If cornflour goes straight into hot liquid, it clumps at once. So make a smooth slurry with 120 ml cold water and pour it in a thin stream.
How do you cut Haupia into clean squares?
Dip the knife in hot water and dry it, and reheat it for each cut. A 20×20 cm tin gives 16 squares of 5×5 cm.

From the same cuisine