Nanaimo Bars

Nanaimo Bars

A Canadian dessert. Takes 1 hr 15 min · +1 hr 30 min chilling, 20x20 cm tin, 16 squares. Difficulty: medium.

At a glance

Total time
1 hr 15 min · +1 hr 30 min chilling
Serves
20x20 cm tin, 16 squares
Difficulty
Medium
Cuisine
Canadian cuisine
Dish type
Dessert
Allergens
Gluten, Milk, Eggs, Tree nuts

Open in the app

Ingredients

Graham biscuits

  • 100 g wholemeal flour
  • 30 g plain flour
  • 40 g light brown sugar
  • 1/4 tsp bicarbonate of soda
  • a pinch of salt
  • 50 g cold butter
  • 1 tbsp honey
  • 1-2 tbsp milk

Base

  • 115 g butter
  • 50 g caster sugar
  • 35 g unsweetened cocoa powder
  • 1 egg (beaten)
  • 160 g graham biscuit crumbs (from the above)
  • 60 g desiccated coconut
  • 50 g walnuts (finely chopped)

Middle layer

  • 115 g softened butter
  • 30 ml whipping cream (35% fat)
  • 20 g cornflour and 1 tsp vanilla extract (in place of custard powder)
  • 250 g icing sugar

Top layer

  • 120 g dark chocolate (55-60%)
  • 30 g butter

Equipment

  • Food processor
  • Rolling pin / oklava
  • Baking paper
  • Baking tray
  • Oven
  • Cake tin
  • Bain-marie bowl
  • Mixing bowls
  • Hand mixer
  • Palette knife
  • Chef's knife
  • Probe thermometer (optional)

Method

  1. Bake the biscuit: Preheat the oven to 175°C. In a food processor mix the flours, brown sugar, bicarbonate of soda and salt, add the cold butter and blend until sandy. Add the honey and milk and stop when the dough clumps together. Roll the dough out to 3 mm between two sheets of baking paper and bake on a tray for 14 min, until the edges darken. Cool for 10 min and blitz to fine crumbs in the processor
  2. Prepare the tin: Line a 20×20 cm square tin with baking paper, leaving it overhanging on two opposite sides. You need this to lift the set bars out of the tin in one piece
  3. Cook the base: In a heatproof bowl, stir the butter, sugar and cocoa over a pan of simmering water, in a bain-marie, until melted. Add the beaten egg in a thin stream and, stirring constantly, cook for 2-3 min, until the mixture thickens and turns glossy. The egg cooks at this point, and if you like, check with a thermometer that it reaches 71°C. Take the bowl off the heat and stir in the biscuit crumbs, coconut and walnuts
  4. Press down the base and chill: Tip the mixture into the tin and press into a firm, flat layer with the bottom of a measuring jug. Chill in the fridge for 20 min, as the base needs to firm up
  5. Beat the middle layer: Mix the softened butter, cream, cornflour and vanilla with a hand mixer. Add the icing sugar a little at a time and beat for 2-3 min, until light, fluffy and spreadable. If it is too stiff, add a teaspoon of cream. Spread it flat and evenly over the base with a palette knife and chill in the fridge for 30 min
  6. Pour on the top layer: Melt the chocolate and butter in a bain-marie and leave to cool slightly for 5 min, as hot chocolate melts the middle layer. Pour over the middle layer and quickly spread to the corners with the palette knife
  7. Score the chocolate: Chill the tin for 10 min and, once the chocolate is half set, lightly score 16 squares with a hot knife. Fully set chocolate cracks when cut, so this scoring gives a clean cut. Chill for another 30 min
  8. Cut: Leave the tin at room temperature for 10 min and lift out by the baking paper. Cut into 16 squares along the scored lines with a knife dipped in hot water and wiped dry, wiping the knife after each cut
  9. Plate: Arrange the squares on a plate with two lying on their sides, so all 3 layers show in cross-section, and one flat. Serve cold

Chef's note

The Nanaimo bar takes its name from the city of Nanaimo in British Columbia. The recipe appears in cookbooks printed in British Columbia in the 1950s and soon became Canada's iconic dessert. The middle layer is traditionally made with ready-made custard powder; here cornflour and vanilla, which do the same job, are used, so the middle layer is closer to pale cream than to the yellow of classics made with custard powder. Cut the squares small, as they are very rich and sweet.

Frequently asked questions

Why does the chocolate layer of Nanaimo bars crack?
Fully set chocolate cracks when cut. Once the chocolate is half-set, lightly mark the squares with a hot knife, as these marks give a clean cut.
Why is the top chocolate layer cooled slightly?
Hot chocolate melts the middle layer. Melt the chocolate in a bain-marie, cool it for 5 minutes and then pour.
How are Nanaimo bars cut neatly?
Leave the tin for 10 minutes at room temperature and lift out by the baking paper. Cut into 16 squares along the marks with a knife dipped in hot water and dried, wiping the knife after each cut.

From the same cuisine